LED border tube shown with wire connector, mounting button and flexible end cap.

LED Border Tube Lights

LED border tube lights are designed as an alternative to neon border light applications. These lights are tested and approved for cold weather use and will not dim or fail to start due to cold weather. Measure 1 1/2 inches tall with attachment button and 1 inch width.Available in 1,2,3,4,5,6,7 and 8 foot lengths PLUS 1/2 inch with end caps and can be field cut in 3 inch increments.
TUBE & LED Colors: red, green, blue, yellow, orange, white and clear tube.
For more information, please contact us. Product samples available.

LED Letter Lights.

Easy Installation

LED border light tubes are easily installed on any surface with minimal surface penetration, unlike invasive wall penetrations required by neon installations and are built to withstand the harshest environments,

Wiring for our led border tube lights can be accommodated through 1/4″ conduit, where code requires. A single transformer will run 60 feet (24 VAC or VDC g-b-w) and 128 feet (12 VAC or VDC r-y-o). Small transformers available for short runs. Neo-Light border tubes can be easily cut in the field to conform to any architectural requirement. Neo-Light led border tubes will easily slide or snap into position after attachment buttons are affixed.
CLICK HERE to view our available transformers, 277 volt trans available.

LED border light tube end caps.

Even Lighting

Shown to the left are the yellow and red end caps which have been replaced with new clear translucent caps for more color transfer between tubes in order to reduce “dead spots”. They are made of a soft rubber material to allow for expansion and contraction.

Caps are glued into place when you receive the light strip. The slot in the yellow cap is for the wire feed to connect one section to the next. New end caps can be installed when tubes are re-cut in the field.

LED border light tube mounting buttons with screws.

Quick Installation

Shown with a mounting screw. These can be mounted onto any interior or exterior surface. The NeoLight led border tube can then be slid or snapped onto the button.

More Information

  • LED border tube system replaces Neon.
  • Consumes 80% less power.
  • 2 year warranty on the LED.
  • 2 year warranty on the transformer.
  • Made with UV protected Plastic.
  • Each tube is sealed against moisture.
  • UL and Canadian approved.
  • Daytime color is the same as nighttime color.
  • Comparable illumination to neon border tubing.
  • Operates in both extremes of temperature.
  • Installs without making large wiring holes in the building.
  • Total Installation cost may be less than neon.
  • Approved for use by many national accounts.
  • Available in white, red, orange, yellow, green, blue and clear tubing.
  • Used with our UL listed class 2 low voltage transformers.

1-877-210-2200

We accept all major credit cards.

Join our
Newsletter!

Borderline LED Lighting
1366 Elm Street
Clarkston, WA 99403