LED Channel Letter Lights
Great for halo light and back lit signs, ponds, stained glass, narrow stroke channel letters and wherever your imagination takes you!
Colors: red, yellow, green, blue and white.
For more information, please contact us.
LED Channel Letter Light Step-by-Step Installation
Step 1
Layout letters to be populated on flat surface. Line(s) of LED per stroke are determined as 1 line every 4″ stroke, 2 lines of LED for stroke that over 4 inches; under 8 inches and so on.
Step 2
Place the LetterLight pieces in the letter can on the back surface wherever possible to decide the footage and the best possible way to populate for the letter. Place LetterLight in the middle of the stroke if only 1 line is required. Place LetterLight 1.5” away from stroke edges if more than 1 line is required.
Step 3
Clip LED Modules on to clips and apply double sided tape on the back of the clip. Sheet metal screw or pop rivet is also suitable for securing clips in letters if extra security is desired.
Step 4
Connect LED modules end to end using provided connectors.( Plug and Play )
Step 5
Clean taping surface before proceeding step 5. Remove backing from double sided VHB tape and press
Step 6
Connect only one end of a chain to power source. For best result, connect two nearest equal footage daisy chains to transformer terminal according to transformer specification. Such as 13ft chain + 12 ft chain of maximum 25 ft. for each 12V’s terminal.
Step 7
If necessary, daisy chain could be formed from next available letter.
Step 8
Secondary (output) wires are color coded as Blue and Red. No polarity matching is required.
Step 9
C2240-12 Transformer 12V 250W, Max. 100 ft
Four terminals, 25 ft max per terminal
C2240-24 Transformer 24V 250W, Max. 60 ft
Three terminals, 20 ft max per terminal.
Provided screw down terminal block is divided into three or four terminals, each terminal is marked as 12V and GND. No polarity matching is required.
